Tractor Talk Discussion Board |
Re: Hauling Tractor - Any Tips?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rhudson on May 21, 2003 at 06:01:32 from (152.31.162.17):
In Reply to: Hauling Tractor - Any Tips? posted by Big Jim Durango on May 19, 2003 at 10:33:03:
Strap or chain (i like straps) as close to front and rear axles as possable. use wheel chocks that are secured so they will not get lost or move as the tractor rocks. straps or chains are also needed to keep the tractor from moving backward and of course from forward (you can bet you will have to brake heavy from someone pulling out infront of you if you're loaded). if you use chains with binders, use wire to lock binders levers down. if you use straps use something to protect them where they come in contact with sharp or keen corners (cardboard, old burlap bags, but something). ok, now double up on the binders, in other words, if one strap will do, use two as a safety factor. it gives you a lot of peace of mind. check for loose fuel caps, SMV signs, hoods, anything that will or could bump, shake or blow loose on the trip home. use duct tape or something to secure things that could come loose. take your time loading and securing. start your trip home, go about 3-10 miles and stop and check you load to see if it has shifted. i use the stop to pick up a snack and diet drink. if you are sure of your load, you can concentrate on your driving and you can relax more. lastly, notice the driving methods of those around you. if other traffic is acting kinda different or whacky, it could be that they see something about your load that you don't. (like 15 foot of chain dragging behind your trailer). take your time and enjoy the trip home.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|