Tractor Talk Discussion Board |
Re: oil pressure/ air filter
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Clint on June 20, 2003 at 08:18:24 from (136.160.129.193):
In Reply to: oil pressure/ air filter posted by phillip on June 20, 2003 at 06:39:21:
From what I'm told the Oliver gauges were only from 0 - 15 lbs. So normal operation should fall between 10 to 15 lbs. Having variables of engine wear and such. Does this sound about right? The oil bath filter should have the same weight oil you put in the crank case. If you're using 30W crank case oil then use 30W in the filter cup. Another good source for questions on the web is "Ask the Oliver mechanic" Larry Harsin. Near the bottom of his web page you'll find the link to ask any and all question related to Olivers. http://www.olivertractor.com/
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|