Tractor Talk Discussion Board |
Re: water in hydralic fluid
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Vern-MI on June 25, 2003 at 09:50:54 from (66.2.148.12):
In Reply to: water in hydralic fluid posted by ron corkum on June 24, 2003 at 13:36:33:
Some of the ways top remove water from oil: First, use a coalescing filter from places like Pall and Velcon Filter companies to trap water that is in the oil in an offline filter media which absorbs water. This is expensive. Second, Vacuum Distillation to remove the oil by first heating the oil and then subjecting it to a vacuum to evacuate the vaporized water. also expensive. Third, like T_Bone said is by stratification although some emulsions are resistant to stratification. The first two are very expensive so the best idea is to drain off the excess water, run for awhile, drain any additional water and all of the oil and then replace the oil with new. One way to test for water in oil is to take a sample of the oil which to the naked eye has no water contaminant in it and put it in a container over an open flame. THIS IS NOT RECOMMENDED. Professional laboratories bring the temperature up over 212 degrees Fahrenheit and watch for water being vaporized from the oil. This is very dangerous and is not recommended for amateurs and should only be done in an open flameproof / explosion proof area, or separate building away from other non-hazardous areas and people, and with everyone being a safe distance away from the container. The operator should be dressed in a fireproof suit and fire fighting equipment should be at the ready. Once the water vaporization temperature is reached all HE double L will break loose and the steam will cause a violent reaction in the oil. This is not recommended for amateurs and if you have ever seen it done you will have a lot of respect for the danger of water in oil in a high temperature system or those above 212 degrees Fahrenheit. Water in automotive automatic transmissions will boil and cause the oil to be burped out of the fill tube onto everything under the hood. Then a fire will ensue.
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|