Tractor Talk Discussion Board |
Re: Gaskets?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TO-35Man on July 06, 2003 at 06:05:22 from (209.86.129.103):
In Reply to: Gaskets? posted by Sean W on July 06, 2003 at 00:09:28:
I agree proper torque is paramount to a good seal but there are more things to check...it may look clean and flat but check it and you will know for sure, use a known straight edge and feeler guage to check flatness on block and head.Antoher common mistake is cleaning those surfaces with a grinder with sanding pad or wire brush attachment these will leave the surface uneven enough to cause a leak if your not careful. 3m makes a rubber pad gasket remover for use on small grinders they work good and dont distort surfaces.Always tap head bolt holes and check bolt thread pitch with a pitch guage or just run a proper size nut on it if you cant run nut on it by hand replace bolt after all its over 20 years old,also check bolt for pitting.Every time you torque bolt it stretches it may have reached it stretch limits ,if while torquing it, it pops or squeaks its time to replace it.I always use copper coat spray on sealer on all head gaskets and any gasket that is not cork and I also lightly spray head bolts or head studs only takes a little dab on each.I build a lot of engines and have not had one leak when I do this. good luck on your next restortation hope this helps....
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|