Tractor Talk Discussion Board |
Re: Re: Re: Hay removal dilemma
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on July 10, 2003 at 12:27:24 from (206.10.55.183):
In Reply to: Re: Re: Hay removal dilemma posted by GlenninPa on July 10, 2003 at 12:10:16:
Ok, I understand. If you can get a layer (front face) of bales peeled off, after that a fork should work. You stick the fork into the side of about 1/3 of a bale, and it should lift out. The very top & very outside is difficult, the inside becomes easier. Also the twine becomes a hinderence, you wish none of it was left! :) Loose hay you would stab down from the top, but baled stuff with the twine rotted off you want to stab from the side. It is slow, dirty, hard work. And maybe the problem is different than I imagine, but really the hay should be in 14x18" cuts already. If you've never worked with hay & a pitch fork, might want to set aside a few hours & practice with it, difficult to explain it, but a pitch fork can require some skills & technique to make it work right. You'll hit upon it if you keep trying. If you are more experienced at this than I'm giving you credit, no insult meant. Just trying to cover the simple bases & help out if I can. (I've watched my wife work with a pitch fork - she comes from small-town, & I never realized a fork was so difficult to learn how to use & apply properly! No insult to my wife, either, she's a smart cookie & I thank her every day for being willing to learn & work at it.... I grew up on a farm, & have never realized the tools I use every day I learned to use when I was 6, and it's not easy to just pick them up & go - needs time to figure out. She's teaching me a lot too.) --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|