Tractor Talk Discussion Board |
Re: Re: tractor overheating
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Deas Plant. on July 20, 2003 at 12:32:43 from (210.50.60.9):
In Reply to: Re: tractor overheating posted by wdTom on July 19, 2003 at 18:32:48:
Hi, All. I certainly would NOT be following wdTom's advice if it were my tractor or vehicle. Firstly, there are very few unpressurised cooling systems left running these days and taking the cap off of a pressurised system while it is hot is a recipe for extensive skin grafts unless you are very careful. On top of this, removing the cap and/or releasing the pressure causes an immediate drop in the boiling point because the more pressure you have within the system the higher the boiling temperature. Likewise running the tractor without the cap so that you can stick a thermometer in the top of the radiator is going to give an unrealistic result on anything but a totally unpressurised system. Secondly, 200 deg. F. would be O.K. but since the boiling point of unpressurised water at sea level is 212 deg. F., running to 220 deg. is highly likely to result in a massive outflow not only of water from your cooling system but also of dollars from your bank account. Incidentally, as I understand it, the higher the altitude at which you are working, the lower the boiling point, unless you have a pressurised cooling system. BTW ewk, one other thing to check would be that your tractor's thermostat is working. You can do this by dropping the thermostat into a pot of boiling water and watching for several minutes to see if opens as it heats up. Hope you find a solution. You have a wonderful day. Best wishes. Deas Plant.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|