Tractor Talk Discussion Board |
Re: Re: Re: IH 560 hydraulics
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe Evans on August 01, 2003 at 10:46:05 from (209.41.233.159):
In Reply to: Re: Re: IH 560 hydraulics posted by Aces on July 31, 2003 at 15:09:56:
Aces: I wouldn't characterize the tranny/hydraulic oil as getting real hot. Let's just say that when the oil gets to normal operating temperature during a summer day is when the sytem poops out. Another symptom of what I'm experiencing is a continual whine in the area of the hydraulic pump and maybe from the control valve body area. Prior to me adopting this 460 from my late father, it can be said that the hydro system rarely worked properly even when there was sufficient pressure produced by the pump. I recall the fast hitch arms not staying at the level you set them at with the control lever--seems like that wanted to "hunt" up/down a few inches all the time. Last time I disked with the 460 it didn't produce enough pressure to raise our transport disk unless you were running near full throttle and even then it was maybe. I don't see an easy way to check the pump pressure output unless I buy a special adapter fitting to screw into the port on the pump's side.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|