|
Tractor Talk Discussion Board |
Re: How much wieght?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kyhayman on August 06, 2003 at 12:33:21 from (64.12.96.236):
In Reply to: How much wieght? posted by Kydirtfarmer on August 06, 2003 at 04:04:39:
Best of luck with this. I had a 7710 Ford with radials and not fluid. Did great, didn't even know the tires were empty until I tried to pull a wago load of roll bales up a frozen hill, oops. Couldnt stop it either. It also rode really rough. Put fluid in the tires and much improved. Later put bias plys on and the ride got even better. Not sure where you are located but they guy that does mine is very reasonable on his farm calls to repair tires. He'sin Harrodsburg, never longer than the next day and a $100 bill gets the farm call, and the new tube with a little change. 1200# of iron will run about $600. That will buy 2 new rims and pay for 4 flats fixed. Anxious to hear if you like it. Best of luck. David
Follow Ups:
Home
| Forums
Today's Featured Article -
Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
