Tractor Talk Discussion Board |
Engine Head Problems
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don on August 21, 2003 at 13:09:32 from (198.140.63.35):
I have an old tractor with an air-cooled Wis-Con engine. The Aluminum head melted and I now have a ½” valley from the piston chamber to the outside. I ordered a new head and gasket, which is on the way, but I have a question on why or how this may have happened. I do not want to melt the new head. Recently the engine has been stalling when a load is placed on it. I then have to stop what I was doing (it has a front-end loader on it and I am moving dirt) and wait for the engine to return to full throttle. The engine goes from a near stalled state and surges to running at full throttle. Could this have caused my problem? Also any ideas on how to stop the stalling when a load is placed on the engine? I have replaced several parts, readjusted the governor rod on the engine and cleaned the carburetor a bit. I was thinking that I may need to rebuild the carburetor but I would rather do this as a last resort. Thanks for any info. Don
Follow Ups:
Home
| Forums
Today's Featured Article -
Check Your Coolant - by Bill Radford. Great tips on how and when to check the coolant in your tractor.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|