Tractor Talk Discussion Board |
Re: What size round bale can I haul?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KX on September 09, 2003 at 06:59:19 from (38.115.0.254):
In Reply to: What size round bale can I haul? posted by OKRon on September 08, 2003 at 19:43:39:
I agree with the below posts on the trailer type mover. I made one so I could use a tractor that doesn't have 3 pt. You can make one that has a hyd cylinder on it to lift the bale or a manual winch that you crank up by hand. That would be much easier on your small Ford tractor. It will keep your front end on the ground as well and I would think you could move any size bale 4x5, 5x6 4x6 whatever. Email and I will send you a pic of the hay mover I made if you like.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|