Tractor Talk Discussion Board |
Re: Ford 5000 broken PTO shaft
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on September 17, 2003 at 20:55:56 from (142.177.95.119):
In Reply to: Ford 5000 broken PTO shaft posted by craig on September 17, 2003 at 13:09:29:
I assume you mean the output shaft, 540 only. You'll have to pull the lift rocker, and the right hand axle, to get access from in front to get the driven gear off. Then take the bearing retainer off and pull the shaft. Drive shaft will pull out from access cover forward of top link rocker. If you have 540/1000, just pop the circlip, and haul the stub out. Be sure to block and support the tractor well when you go to take the axle off. Probably need a little crane or boom to lift the axle, or a few real strong bodies. I'm thinking 500#, give or take. Hope this helps you out. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|