Tractor Talk Discussion Board |
Re: 12g shotgun loads
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris-se-ILL on September 19, 2003 at 06:53:01 from (216.174.170.137):
In Reply to: 12g shotgun loads posted by Bruce on September 19, 2003 at 06:10:41:
(quote)"Can anyone tell me the correct load/construction for the starting charge??" NO, not with the little info that you have given. If you have reloading equipment then you should have gotten a "Reloader's Bible" or reloading manual that tells the specifics of each load! Hull manufacturer, shot size, primer selection, wad manufacturer and style, target and shooting requirements, all these plus more specs factor into the equation! .....and if you don't already know this.... why are you reloading this guys shells? I don't mean to be a smart-aleck here, but experimenting and random loading is not an option! If you have already loaded shells before and know the variables that apply, then have the gun "proofed tested" by a competent gunsmith and then start with as light a charge as the reloaders manual suggests, for the hulls and wad that you plan on using! Good luck and be extra careful! I have a 12G shotgun setting in the corner that has a golfball sized hole in the side of the barrel where a guy made a mistake and a piece of the barrel took the end of his thumb off (he's very lucky it didn't kill him or someone else)! I use it to show kids what happens when you do not pay attention to details!
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|