Tractor Talk Discussion Board |
Re: Mixing calcium chloride
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on October 02, 2003 at 17:51:15 from (12.148.160.138):
In Reply to: Mixing calcium chloride posted by Dieselrider on October 02, 2003 at 16:56:49:
Hi Dieselrider, I have mixed up and installed my own CaCl solution in tractor tires. You use about 2-3 Lb CaCl 77% Flake per gallon of water. See this pdf file from Dow Chemical. The freeze point shown for various mix ratios does not have to equate to the lowest ambient temperature for your area. My area occasionally gets to -20 deg F but a mixture with a freeze point of +10 deg F is quite satifactory. A slush will begin to form at +10 but the solution will not freeze solid at -20. The fact there is slush in the tire will not be a problem. You just mix it all up by stirring until all the flake is dissolved. The mixture will get warm in the process . Yes, you can elevate a drum so the solution will flow by gravity into the tire. Keep the valve stem in the top vertical position and vent off air every once in a while. Use the special fill fitting for this purpose. I have used a 50 gal drum elevated in a front bucket loader successfully this way. It's slow but works. I have also used a small Simer pump (garden hose connections) to do the job. That's a faster way but is not really necessary if you are doing the work for yourself and don't mind taking some time. If you use any kind of pump, make it a cheap throwaway unless it is an expensive pump designed specifically for CaCl solutions. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Antique Tractor Wiring Basics - by Curtis von Fange. One of the most neglected parts of old tractors is the wiring. After sitting in the elements for half a century or more much equipment wiring has deteriorated to sparsely covered strands of copper or other metal. Plastic insulation has cracked, mice have eaten through the older clothed style coverings and the exposed wires have reacted to winter moisture and salts by turning blue and powdery. Terminal ends have corroded, rusted or just plain evaporated away. Aged wires not only keep an engin
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|