Tractor Talk Discussion Board |
Re: Antifreeze
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by WayneB on October 23, 2003 at 04:28:37 from (67.213.51.248):
In Reply to: Antifreeze posted by JC on October 22, 2003 at 04:53:22:
DexKool. Marketing strategy. Designed for newer aluminum radiators. Designed to separate the yuppie from $$$; also requires total flush of green ($$$) Not worth the $$$ on farm/construction equipment. Reasons for changing and flushing coolant. Particulates swirl in the cooling system, eroding and lodging. Acidic levels rise, weakening hoses. Deposits heat and cool, solidifying and clogging radiators. Occasionally, getting these floating eroding conaminates out is worthwhile. A coolant filter is optimum, but in the long run, flushing the coolant system is fairly cheap. Everything said so far is good advice. The color of the (green) coolant is a good clue to flush need. Bright green---good. Green-ish--Brown, flush!
In the military, we have worked with antifreeze recyclers. One you can plug into a heater hose, and run the equipment for ten minutes and totally filter and replace the inhibitors. Ethylene-glycol, the root ingredient of antifreeze is clear, the green or orange color, is just tha---color. The recycler removes inhibitors, color, and also completely filters, the remaining glycol and water is clear, then the inhibitor lubricant package is added back which gives the coolant color.
For used antifreeze, additionally, we use coolant test strips, which test for freeze-point concentration and acidic level. Inhibitors can be added just once bringing the acidic level within tolorance, then thereafter, the coolant must be flushed. Equipment that is used on a continuous basis, and does not sit, will not rust as much as the idle stored equipment, requiring less flushing. Wayne
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|