Tractor Talk Discussion Board |
Re: valves
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on October 27, 2003 at 20:03:59 from (66.163.134.177):
In Reply to: valves posted by sod buster on October 27, 2003 at 18:06:54:
Some exhaust valves, and more rarely, intake valves are set up with rotators. There is the Rotocap type, where the valve uses special keepers shaped like "C's", along with a Rotocap- a hardened steel cup that fits on the top of the valve stem. The action of this is when the rocker arm presses down on the Rotocap, the keeper is released by a few thousandths of an inch, allowing the valve to rotate a fraction of a turn. The other type of rotator is the "positive type", where there are little ramps and springs in the valve spring retainer that rotate the valve a little each time the spring is depressed, also. The purpose of either system is to rotate the valve to make it wear evenly, prevent "hot spots", and this action probably helps keep particles and buildup from lingering on the seat, which could cause the valve to burn. As to your question, you make no mention of the type of engine you are ordering a kit for, which would preclude any guess as to whether your engine has rotators or not. You will have to disassemble it and check for yourself. In some cases, engines that did not use rotators from the factory could possibly have been changed over during a previous rebuild. If you are getting a complete valve kit, with valves, retainers, keepers, and possibly rotators you may be given the choice of either kit... rotators or not, and it would be your choice, depending on cost, but if you are just buying the valves, you will need to verify which you already have, to match the parts up correctly. Are you doing the work yourself, or do you have a machinest lined up... he could probably tell with one glance what you need.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|