Tractor Talk Discussion Board |
Re: what is the hardest oil change you ever did?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Britt on December 29, 2003 at 18:45:47 from (207.69.136.199):
In Reply to: what is the hardest oil change you ever did? posted by Jay on December 29, 2003 at 15:47:40:
A pair of Cat D-399 diesel generator sets. They were in the desert in Saudi Arabia. These were "prime power" sets that were only shut down in an emergency. As such they had dual oil sumps and dual filter banks on each engine. You could switch a valve and run the engine off of one sump and filter bank while you changed the oil and filters in the other sump. Then you would switch the engine over to the other sump and repeat the process. The temperature in the shade was around 110 to 120 degrees. Inside the generator building it was more like 150 degrees. I don't recall exactly how much oil each sump held, but it was around 100 gallons per sump. Needless to say, it wasn't one of my favorite tasks. When I was working outside, I kept my wrenches in a five gallon bucket of water. If you left them out in the sun for more than 10 minutes, they would raise blisters on your hands. When a breeze would blow during the afternoon, it felt just like you had opened an oven door. No one ever went to Saudi Arabia for the climate. I won't even mention the sand storms.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|