|
Tractor Talk Discussion Board |
Re: new laws for chaining
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bret on January 06, 2004 at 18:25:28 from (64.19.94.28):
In Reply to: new laws for chaining posted by bcPA on January 05, 2004 at 12:09:20:
To be exact- If you are in commerce and you have a truck OR trailer with a gross vehicle weight rating, GVWR, over 10,000 lbs there are now commodity specific tie down requirements. Starting 01/04/04 the requirement is that equipment be secured by two sepaerate chains at each end of the machine at the tie down points closest to the front and back of the machine. If it has a boom or bucket that too must be tied down. The tie down used must meet the minimum safe working load required by the weight of the equipment and the hardware also must meet that weight. This is the Federal law. It does not apply if you are NOT in commerce or if the GVWR is NOT over 10,000 lbs. Your state may have it's own laws and I would suggest you call your State Police or whoever handles DOT inspections and check. There are almost as many "urban legends" regarding the tie downs as the new Hours of Service rules. I advise guys to play it safe and chain the snot out of their loads. BTW- 2 tie downs in the first 10 feet doesn't apply to the commodity specific tie requirements. To a regular load it would, pipe, lumber, etc. The new commodity specifc rules apply to equipment, concrete pipe, large rocks and boulders, junk cars, steel coils and few other things that slip my mind.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
