Tractor Talk Discussion Board |
Re: 140 3-pt hitch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AZglide on January 12, 2004 at 18:03:26 from (69.132.59.146):
In Reply to: 140 3-pt hitch posted by Kevin (FL) on January 05, 2004 at 08:43:45:
I use my 140 with a 5' bush hog and have never had a problem as long as my common sense was in gear. Three or four foot bushes are no problem but would be hesitant to go much larger than that. Seems to be at least as good as my NAA plus you are up high enough that you are not getting hit in the back all the time. I'm sure the u-joints will wear faster running at a angle but the angle is not extreme and they will probably out last me. Worksaver 3 point works fine but I believe the attachment of the lift arms could use some improvement, not enough flexibility. Even used it to plow the garden last fall using a Ford 2-14 plow. Pulling it was not problem and a lot easier to control than the NAA. Hope this helps, remember a ORC is a must and watch those banks and hillsides.
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|