Tractor Talk Discussion Board |
Re: not a tractor---but can you help me out??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bruce on January 13, 2004 at 06:09:09 from (24.213.27.142):
In Reply to: not a tractor---but can you help me out?? posted by Bruce on January 12, 2004 at 07:06:16:
Thanks for all the great advice. I am in the process of reinstalling my manifolds to run another test on the engine. Since some of you have worked on these engines, please tell me in which direction the exhaust gasket should go on. It is a small donut shaped metal gasket with a ridge of thin metal on one side. I first installed it with the thin ridge going INTO the engine, after running it only a very short time, the thin ridge is burning up, so now I am thinking it ought to be installed with the thin ridge goin INTO the manifold. Either way, this is a poor excuse for a gasket. Might have to make my own that seal better. I will keep the board posted on my progress. In answer to some of the posts, I do have the manual for this machine, and can now recite them from memory....If my next few tests don't work, then I will pull the head off and have all parts machined to ensure flatness, reseat valves ( including intake) and go at it again....but that is now my last resort. This next test will involve new plug wires, rotor, cap, points etc....timing, and gaskets...then if still hot, do the spray test for leaks... Thanks again Bruce
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|