Tractor Talk Discussion Board |
Re: Re: Re: Ballast
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Indydirtfarmer on January 22, 2004 at 04:52:16 from (66.83.236.250):
In Reply to: Re: Re: Ballast posted by Van on January 21, 2004 at 18:04:57:
Any wieght you put on the wheels, ends up putting stress on the axles, and the axle bearings. If you add 750 pounds to the center of the wheel, it won't have the same adverse effect as adding it to the outer perimeter of the wheel. (Iron wieghts, vs. fluid wieght) Granted, most tractors are designed to handle that wiegh, it just extends the life of the bearings, by not applying all the load they can handle. I have 2 nearly identical tractors setting in my barn. One is a 1956 Ferguson 40, that my uncle bought new. The other is a 1957 Massey Ferguson 50, my father bought new, 6 months after my uncle got his 40. The 50 never had fluid in the rear wheels. The 40 had fluid from day one. I'm currently resoring both of them. They both have about the same amount of hours (With-in 100 hours) The 40 has MUCH MORE wear in the rear end, and rear wheel bearings. It needed brakes long before the 50 did also. While that's not "iron-clad evidence" It's good enough for me. Here's another thing to look at. I have piut together a stainless steel chemical pump, and the hoses needed to pump fluid in and out of tractor tires. The entire package set me back less than $75. I can add fluid when needed, and take it out the rest of the time. It takes about an hour a wheel. The only time I need wieght in my tractor tires, is in the spring when I'm doing what little plowing I still do. The rest of the year, I'd rather have a lighter tractor. John
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|