Tractor Talk Discussion Board |
Re: I’d like to choke my 860!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RWK in WI on January 28, 2004 at 05:57:07 from (169.207.71.248):
In Reply to: I’d like to choke my 860! posted by Dale-SWMI on January 28, 2004 at 01:07:22:
My 860 starts best just above idle. Ignition on, pust starter button with right hand, then as it's turning over pull choke with left hand. If it doesn't catch at once push choke back in and then stop cranking. Try again. On mine never pull choke out then crank. On my 640 and Ferguson TE 20 they like a little more throtle ( but less than 1/4 ) but same procedure. If mine don't start an about the third or fouth try I pull the air tube to the carb. and give it a shot of either before I run the battery down. Hard starting on hundred series Fords can be a sign of water / ice in the air cleaner cup oil. Something to check .
Follow Ups:
Home
| Forums
Today's Featured Article -
Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that ‘quick look over’ before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|