Tractor Talk Discussion Board |
Re: I’d like to choke my 860!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on January 28, 2004 at 11:52:14 from (65.178.208.129):
In Reply to: I’d like to choke my 860! posted by Dale-SWMI on January 28, 2004 at 01:07:22:
Granted, every engine is different, but any well-tuned gas engine should start at one-fourth throttle. Higher settings cause more engine wear, because the engine is cold and the oil is not circulating to the crank bearings. Doesn't matter if you pull the choke before cranking- the choke does not add gas- it reduces air flow, and that does not happen until cranking starts. Some engines, when started in cold weather might still need a bit of choke for a minute or so. If you've cranked with choke to the point where you smell gas- you've flooded it, and it is not likely to start until you let it set for a time. Generally a few seconds of choke is enough. If you need to wait, hook up a battery charger- batteries have very little power at cold temps and run down soon.
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|