Tractor Talk Discussion Board |
Re: Re: Your carb should NOT leak......Carb 101
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott on February 03, 2004 at 12:55:06 from (216.43.77.143):
In Reply to: Re: Your carb should NOT leak......Carb 101 posted by Why do they leak?? on February 03, 2004 at 12:00:23:

Here is the parts that are subject. This is one of the last two pictures on the page I gave you. One of these parts has to do with it. Big brass thing is the float, needle and seat are under it, better shown in the next pic on the page. What was said below is correct. Think of it like your toilet. If the float is too high, the water runs to the over flow (out your breather hose or carb gasket). Needle bad is like the shut off being bad, ie: toilet keeps running water in and right back out the over flow.(carb leaking a little over time will cause it to go over and leak out the air inlet). If you poke a hole in the float, it won't float back to the top....just like a carb.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|