Tractor Talk Discussion Board |
Re: Which Detroit sounds the best?. Noisy engines
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne on February 04, 2004 at 19:07:55 from (205.188.208.73):
In Reply to: Which Detroit sounds the best?. Noisy engines posted by Jonathan on February 04, 2004 at 07:59:37:
Out of all the posts on here nobody mentioned how good the old Murphys sounded. The Detroits definately have an unmistakable sound. Still there is nothing sweeter sounding than a Murphy in a dragline whan you start pulling the bucket back in and you hear her load up and bellow. I guess being a slow speed engine at 1200-1300 RPM Max, it's on the opposite end of the spectrum than the higher speed Detroits and as a result just has it's own distinctive sound to love. The other sound I used to love was the main High Pressure turbine on the USS America CV66. It had an extra set of nozzles that opened halfway through turbine at high speeds. By throwing the full HP steam pressure in at the midpoint it acted, for want of a better term, like an afterburned or turbo for the turbine. I used to love opening the throttle valve that extra little bit. Now that she's been decommisioned I guess I can brag a little, I've seen the old girl run at 35+ knots or 40MPH+. Not bad for a floating airport..... Talking about the Detroits there is a site with sound clips from different model Detroits on Yahoo somewhere. I had a link at one time but lost it somehow when I switched one of my comuter programs. Maybe somebody else out there has it or knows where it is.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|