Tractor Talk Discussion Board |
Re: Remote hydraulics questions (kinda long)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Thomas on February 11, 2004 at 11:25:57 from (80.168.173.8):
In Reply to: Remote hydraulics questions (kinda long) posted by Bud on February 11, 2004 at 09:13:08:
If you're going to run a feed like that you must make sure that the valve block you're using is big enough, otherwise the oil will overheat and damage the tractor. I'd think a CETOP 5 would be the minumum requirement. For 'free falling' you need a valve which has a float position on that service. Decide exactly how many services you require before spending any money as it's very difficult add extra spools 'in line' at a later date. For example, you might want some sort of hydraulic post holding clamp or hydraulic foot adjustment. I've often thought about making a post rammer, I thought about using an electric solenoid block. This would allow you to site the hydraulic components neatly and have a control pendant (like you get on workshop cranes) to allow you to operate the machine from a convenient place (holding the post straight with a bar could be done by one person). You buy a base plate with the required number of services and then add suitable valves which could be of several different configurations. Try to find an agent for Denison Hydraulics, I've used their valves on several occasions and found them to be very good. I once saw a post rammer which had been mounted onto a loader, looked good as it enabled access to tight corners and over ditches where a rear mounted unit wouldn't go.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|