Tractor Talk Discussion Board |
Re: ATF vs hydraulic fluid
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bruce on February 14, 2004 at 12:28:09 from (24.213.27.142):
In Reply to: ATF vs hydraulic fluid posted by Bruce on February 14, 2004 at 09:46:35:
Here is the long story. I contacted Bobcat corperate office, after three people did not know the answer, they said " someone will get back to you." Then a contractor friend of mine stopped at my office, and he said he uses hyd oil, but he gave me the number to his dealer. Dealer looked in his service manual ( which I have too) and said " the manual says use 10w30 oil, but we use hyd oil" I pointed out that the manual says "use 10w30 then later on says use ATF" it was the first time he noticed the error in the manual. Anyway, he convinced me to use hyd oil. Now, three hours after calling Bobcat Corp, a service person calls me, and I explain the issue, he says " boy...that machine is older than I am, I think you should use hyd oil, but then again, ATF would be better for the clutches, I don't know, let me check with some other service people..." He calls me back 1/2 hour later ( I give them credit for even dealing with my old machine) And now he says...."use ATF" I call the dealer back and say to him..."guess what?? Bobcat says to use ATF..not hyd oil" Dealer says..." No Kidding???? why? Here I am a dealer, and I don't know what I am suppose to be using!!!! I said.. "now you do..." So, long story, but after listening to all the differant views on this, then considering the viscosity issue, I thought I would post the question here and hopefully get the view of those with more experance than I have, because, at this point, I think either oil would work, just which one is better than the other??
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|