|
Tractor Talk Discussion Board |
Re: F-M Magneto Dissasembly Questions.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gregPA on February 18, 2004 at 05:50:09 from (216.141.88.250):
In Reply to: F-M Magneto Dissasembly Questions. posted by Chris(WA) on February 17, 2004 at 16:52:53:
hello Chris. i'm in the middle of the same project. got help from both this board and the AC board. if you check the AC board there is a post by me asking for info about the mag. fellow that answered me included a cross section view of that mag. that helped. my mag is off a B. i used an O-ring pick to get the seals and covers off both sides of the rotor. once that's out of the way you will see the retaining clips. one on either side. my original problem was removing the impulse coupler. the guys told me that it was on a taper. put the puller on it and popped it off. then things opened up and i could see. after removing the covers seals and retainers. i pressed the rotor shaft out of the housing. just slightly tighter than a slip fit. bearing stayed in the housing. then just pushed the bearing out using thumb pressure. i had to machine a new bronze bushing for inside the cap housing. the cap rotor gear was flopping around about .020, not good. also the main reason i tore it apart was that someone somehow badly cracked the alum. housing and i am getting it welded. i should have that done today and can start reassembly. i'm fairly new to these mags but i got the help i needed off the board. greg
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
