Tractor Talk Discussion Board |
Re: Farmall H siezed Engine 1 cyclinder full of w
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris Vangel on February 20, 2004 at 17:14:42 from (66.136.184.142):
In Reply to: Farmall H siezed Engine 1 cyclinder full of water posted by Mike Linderman on February 20, 2004 at 14:44:01:
Howdy. I am a 14 year plus auto mechanic. I learned a new trick (new to me, anyway)I thought of it myself and have told a few others to try it. I have had locked engines before on tractors and outboards that were stored in poor manner. I filled the cylinders as you did with penetrating oil or motor oil or whatever lube I had. Then let it soak awhile. Here's what I did different that worked for me. I took the end of my compression tester and screwed it into each spark plug hole, I then hooked up pressurized shop air to the hose. Adding 125 psi of pressure to the oil in the cylinder forces the oil around the rings. This helps quite alot. Consider it to be 'speed soaking'. After soaking and pressurizing, try to turn the engine by hand first. Sometimes the air pressure itself will turn the engine as it forces the piston down. Of course this only works for cylinders which have their valves closed. Turn the crank both directions by breaker bar and see it it breaks loose. If it turns, make sure that it turns 360 degrees. If is possible to have a valve stuck wide open and you don't want to bend it with a piston using the starter. If you hit it while turning by hand, you won't be able to turn 360 degrees and shouldn't bent a valve. I don't like to use the starter because if something is stuck badly, you can bend a connecting rod or damage the starter drive. I have used this method a few times and been successful. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|