Tractor Talk Discussion Board |
Re: Re: Cleaning gunk out of engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ol Chief on February 27, 2004 at 19:09:07 from (63.246.186.23):
In Reply to: Re: Cleaning gunk out of engine posted by Bill Smith on February 27, 2004 at 09:56:04:
There are a number of engine flushes available at auto supply stores.I do not know the recommendations for use of these individual products. In general the advise adding these cleaners to an already warm engine and operate for five minutes at no load. Then drain. An alternative is to ad about one pint or less to begin with, of automatic transmission fluid to the oil and operate as normal and drain. That stuff is very high detergent and will break down loads of parafin,carbon and varnish.If you go that route I suggest you not wait for a long period before oil change,to get rid of the contaminants.Then do several follow ups until you have a clean engine. It works.Do not go at you problem to heavily or you may partly block the oil pump suction screen. Watch the oil pressure gauge.
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|