Tractor Talk Discussion Board |
Magneto ignition
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Walter on May 13, 2004 at 13:02:36 from (165.121.132.157):
I'm trying to get my Swiss-made 1960 Rapid 2 cylinder walk-behind tractor started. I think there is a magneto problem, as I have no spark. I happen to have a new replacement ignition magneto coil that mounts on the flywheel, but I don't want to use it unless the old one is bad. Both the old and new coils have two wires, a large high-voltage secondary that goes to the distributor cap and a low voltage that goes to the points. The high voltage shows 5K ohms to ground, whereas the low voltage shows zero ohms to ground. Is this normal, or does it mean they are both shorted out. That would be odd since the new one is new and unused. Maybe both coils are fine and the problem is somewhere else. Is there any way to troubleshoot the system? Any magneto experts out there?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|