Tractor Talk Discussion Board |
Re: Re: Re: Fuel cost
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TomR Ont. on May 22, 2004 at 18:40:10 from (206.172.193.81):
In Reply to: Re: Re: Fuel cost posted by jdemaris on May 21, 2004 at 20:08:57:
I must disagree with you! The biggest problem we have with our.... Health Unemployment Roads Compensation systems ...... is that, taxes are collected for these systems, some of them, the tax is put in a fund to pay for it, BUT as soon as there is TOO MUCH in that fund, it goes into the GENERAL FUND, and before you know it, it all goes directly to the general fund, the people who look after the general fund use it like a disfuncional family with dads pay cheque. Slowly there isn't enough TAXES comming in to to pay all the NEW BILLS and the social expenditures. So they raise taxs on the premise that there is not enough money for the social expenditures. We have a tire tax that's was to pay for the roads, it goes straight in the general fund and they don't enough money to fix the tire size pot holes all over Ontario. What they don't think of is, it's TAX money not theirs, our Governer General spent close to $40+ mil. last year, and that's just one of our disfuncional family. They should just take 80-90% of our income and save a lot of wasted expence collecting it by bucking us into the poor house. Think of the big corporations that don't want to pay taxes, where do we get the money from, to pay income tax and all the hidden taxes (higher wages). I think it still comes down to GREED with a pinch of stupidity. Just look at the difference in the cost of drugs between Canada and the USA, the drug companies wants Canada to increase the cost here to stop USA cross border drug shopping. It saves your seniors 40 - 100%. The drug companies say our drugs might not be safe, and there made by the same companies as yours go figure. We have different rules on drug pricing, but I'll bet they will be changed so OUR DRUG costs will = yours in a few years.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|