Tractor Talk Discussion Board |
Re: catepillar tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Adam B. on May 25, 2004 at 03:02:33 from (4.229.168.120):
In Reply to: catepillar tractors posted by gabriel on May 24, 2004 at 23:14:46:
I'm not very familiar with most developments outside the U.S. Caterpillar is a trademark name. Apparently, when their tractor on tracks was being developed, an observer noted that the tractor's movement looked like a caterpillar's, so the name was adopted. Caterpillar (the company) is the result of a merger between Best Mfg. and Holt. Both companies manufactured farm equipment, among other things. At least one of the two, I believe it was Holt, had a 'track laying' drive system for steam engines. It wasn't a full undercarriage, but a half-track configuration that only replaced the traditional rear drive wheels. That should have been sometime around the mid-to-late 19th century. (Holt and Best merged in 1925 to form Caterpillar.) Following Caterpillar back to its Best and Holt roots is probably going to find you your answers to the who/what/where/why/how questions about the first crawler tractor. Although, it is possible crawlers were in development earlier or around the same time in other countries. Crawlers were most popular on the West coast, (especially the Pacific Northweast), New England (snowy regions), and in the South (swampy areas). Lindeman Mfg. Inc. of Yakima, Washington was building a crawler conversion of the John Deere BO. I think they started with conversions of complete tractors, but demand led them to start buying incomplete BO tractors (without front axle or wheels) from John Deere in 1940. It was called a John Deere-Lindeman. In popular John Deere tradition (easier to buy out a good competitor than start from scratch in a new market) JD acquired Lindeman and called it the Yakima Works. The Lindeman tractor was soon gone, replaced by the MC. The Yakima Works made just the track systems at that point, and shipped them to Dubuque. The Yakima Works also became a special branch of JD, making some extra heavy-duty implements (like tillage and land-leveling items). That isn't really relevant to your question though... This is all to the best of my knowledge, but ought to be accurate enough to be a solid jumping-off point. Good luck with your research. Hey! After I finished writing the above, look what I found...
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|