Tractor Talk Discussion Board |
Re: Hydraulic chatter or jerking
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TomR Ont. on May 25, 2004 at 19:26:54 from (209.226.138.89):
In Reply to: Hydraulic chatter or jerking posted by Tomas on May 25, 2004 at 10:07:05:
I have a Yanmar 240D (hey guys it's green and old) I had a similar problem chatter and jerking only slow. The knob under the seat for the 3pt hitch was turned off soon as I opened it, the loader works fine. According to the book I have to find netural in the control leaver for the 3pt hitch and set the feed back rod. If This the Problem I could e-mail you a copy of the page.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|