Tractor Talk Discussion Board |
Front mount pump on my Massey 135
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by D.W. Gill on June 02, 2004 at 14:11:07 from (24.247.135.110):
I am attempting to remove the front mount hydrolic pump off my 135 to replace the rear shaft bearing.(The outer race has come out of the housing) I have removed the two bolts holding the pump on the tractor housing and have also removed the bolts attaching the splined plate to the crankshaft. The pump however will not budge. I have been spraying "breakfree" on the rearbearing and have a 2 ton comealong applying pull pressure on the pump with no luck. Any ideas short of tearing the pump mount off the tractor, which is half the front end?
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|