Tractor Talk Discussion Board |
Re: 901 SOS diesel ... is it for me???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on June 03, 2004 at 05:32:59 from (199.46.199.230):
In Reply to: 901 SOS diesel ... is it for me??? posted by paul_h on June 02, 2004 at 22:16:04:
I have 2 Ford diesels and they are tough, reliable, and extremely economical engines. Pull tough also. The SOS is an auto tranny just like in your car. It has a cluster gear with "bands" that squeeze the shaft of the gear you want and that is how power is transmitted. The bands are the wear item , just like in a car, and would be the best indicatior of useful life. There are 3 bands on the Ford SOS and each is adjustable from outside the tractor. If you say it has a solid shift (thud, not swish when you put it in gear or change one) you can get an Idea of useful life by looking at the threads sticking out of the adjustors. I haven't looked lately, but if you look at the side of the transmission housing somewhere around 1/2 way down you'll see 2 very large nut/screw threads, with a slot in the end of the screw part, on one side of the tractor and 1 on the other. You loosen the nut and screw the thread in to tighten. If you can see 1/2 " or so of thread sticking out of the nut you are in great shape; lots of adjusting room left so you don't have that much wear to worry about. NOTE: I'm not telling you you have to tweak them just to be doing it; just supplying information. When the time comes that you may want to do it, come back and ask and someone will tell you how. However, if the thread is half way thru the nut you are on your last leg and the bands will fail you before too long. If the bands are loose, the transmission will not pull, it slips and the engine revs up and the ground speed falls off. Above all, keep your fluid clean. I think Larry NCKS (herein) can be called on to prescribe the correct fluid but I think I used HY/Transmission fluid in mine; same stuff I put in the hydraulics. During winter, the fluid is thick and the PTO and tractor may want to creep on you. If this is a problem, don't buy it or just turn the engine off when trying to connect to something if it bothers you. Now, you are prepared to make your own decision. Good Luck, Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|