Help!!! advice for 1st time at painting a tractor

Posted by Charles D. Zook on April 11, 1999 at 15:09:40:

Working on case 311b-- have front wheels,& all
sheet metal sand blasted & primed, purchased 2 quarts of desert sunset & 2qts. of power red, at case/ih dealer-- is this enough paint? What is proper preperation for sheet metal at primed stage
& what is needed on engine, trans., rear end, & rear wheels, in prep.& type of primer? I have a 3
h.p. compressor,purchased a air filter & regulator
& new spray gun. Am now reading & looking for advice on preperation & painting procedures, for
a first time attempt at painting.
Any info. is appreciated, Thank You
Charles D. Zook

Follow Ups:

• Re: Help!!! advice for 1st time at painting a tractor Jim WI 11:14:50 4/13/99 (1)
  • Re: Re: Help!!! advice for 1st time at painting a tractor Dave Zook 15:10:07 4/13/99 (0)
• Re: Help!!! advice for 1st time at painting a tractor Crook 16:34:34 4/11/99 (3)
  • Re: Re: Help!!! advice for 1st time at painting a tractor Dave Zook 14:52:47 4/12/99 (0)
  • Re: Re: Help!!! advice for 1st time at painting a tractor Dave Zook 14:44:13 4/12/99 (1)
    • Re: Re: Re: Help!!! advice for 1st time at painting a tractor Crook 22:44:41 4/12/99 (0)
• Re: Help!!! advice for 1st time at painting a tractor Shaun in Wisconsin 16:24:08 4/11/99 (1)
  • Re: Re: Help!!! advice for 1st time at painting a tractor Dave Zook 15:02:03 4/12/99 (0)

Post a Followup