|
Tractor Talk Discussion Board |
Re: Off-topic...Update...Boss at work
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DaveWis on June 11, 2004 at 01:17:31 from (136.2.1.153):
In Reply to: Off-topic...Update...Boss at work posted by kentuckykid on June 10, 2004 at 19:21:23:
I agree with the other posters, you will only get more misserable as time goes on. Just make sure you leave on your terms but at the same time try not to give him any reason to give you a negative referance from an attitude standpoint. Good luck in your future, I'm sure you will make it just fine. Have faith in yourself and keep a possitive attitude. As a side note I've dropped u-joint needles more than once. Just clean them up good and put them back in the cap.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
