Tractor Talk Discussion Board |
Re: OT New home wall thickness
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greenbeanman on June 11, 2004 at 05:06:06 from (4.244.81.134):
In Reply to: OT New home wall thickness posted by Kent on June 10, 2004 at 18:09:16:
Spending $90,000 for materials means to me that your home will be about a $200,000-$250,000 valued home when completed. You have proposed the minimum insulation amounts. "DL" spoke of super insulated houses. I have also done considerable reading about them. One home builder in upper New York state builds with R-50 sidewalls and R-90 ceilings. He uses lots of caulking and sealants. The extra money required for the higher R value insulation comes from the homes he builds requiring NO HEATING SYSTEMS. The normal heat producing activities, such as from the hot water heater, cooking, the heat produced by computers, televisions, lights, provides all heating. The homes are so tight that of course an air-to-air heat exchanger is needed to provide fresh outside air for the home. While you asked about insulation, I'll throw out some other thoughts too. Please get a GOOD book on the latest framing techniques. They provide strength while also providing "thermal breaks" to stop the transfer of heat. Also use the latest recommendations for wind strapping, i.e. roof hold down clips as well as else where. You spoke of cutting back on windows. Please don't cut back on the south side of the home. For maximum solar gain in the winter, a home needs 10% of the floor square footage in windows. You owe it to yourself to build properly as this may be a once in a lifetime structure. Saving monthy energy expenditures will help pay the taxes and the mortgage should you have one. May your building project go swiftly and provide you with a home even more wonderful than anticipated. Cheers.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|