|
Tractor Talk Discussion Board |
Re: Re: Re: Re: TEA 20 12Volt Conversion Ammeter Q
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George H on June 28, 2004 at 08:13:17 from (64.112.197.154):
In Reply to: Re: Re: Re: TEA 20 12Volt Conversion Ammeter Quest posted by Jon H on June 27, 2004 at 06:15:17:
Guys, Particularly Ron and Jon...thanks for all the information. I've learned a LOT about charging systems from your dialogue. The battery I was using was new...I ASSUMED it was charged, wrongly. After charging it three hours yesterday my charge rate upon starting was no higher than 12 amps at working rpm, fell to discharge at 400 rpm, about 5 amps at about 1000 rpm. I have the #2 connector wired, with the alternator output ("BAT") terminal to the ammeter, then from the other ammeter terminal to the battery connection on the terminal block. I will remove the #2 connector and wire it directly to the "BAT" connection, as to be certain my ammeter isn't interfering. It doesn't appear at this point that either the alternator or battery have been damaged by the experience. Hope this sheds a little light on the discussion. Thanks again for the outpouring of information.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
