Tractor Talk Discussion Board |
Re: Getting rid of poison ivey/ poison oak??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by UFO Man on July 21, 2004 at 17:34:01 from (66.243.138.22):
In Reply to: Getting rid of poison ivey/ poison oak?? posted by cheap_dave on July 19, 2004 at 18:10:47:
Dave, there was an episode on "Ask This Old House" just the other day. If you cannot use a systemic poison, like "BrushBGone", you have to tear it out. I agree on the method that they used, it is the only way that I have ever been able to control this vine. We have horses and cannot use herbicides. PULL it up by the roots, double bag it and send it to the land fill. Mulch 6 inched deep over the area with wood mulch. The roots left in the ground will not be able to send up vine far enough through the mulch to get started and will die. When you pull it, wear long sleeve heavy shirt with gloves, taped where the shirt and gloves meet. Tape your jeans to your boots at the cuff. Wear goggles, poison ivy in the eyes must be miserable. Wash your clothes with an oil cutting detergent or double bag them and send them to the land fill. Wash any exposed skin and any skin that touched the outside of your clothes with an oil cutting detergent or soap and COLD water. Warm water opens your pores and the ivy oil will get into your skin. This is hard work, but pays off. Cutting it only encourages the growth. Luckily, neither me or my wife are allergic to this vine, but I don't like it on the property. I spent the first five years pulling gobs of it up by the roots. Since then, there has been little volunteer growth, which gets yanked out by the root. Good Luck, UFO Man
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|