|
Tractor Talk Discussion Board |
Re: Re: Re: CAN A CHEVY 350 BE INSTALLED IN AN ALL
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott on July 28, 2004 at 08:54:27 from (69.66.128.95):
In Reply to: Re: Re: CAN A CHEVY 350 BE INSTALLED IN AN ALLIS W posted by Dick2 on July 27, 2004 at 15:14:28:
The "What Next" AC that was referred to I believe belonged to Tim Glassnap of Lytton, IA. I think he ran a big block Chevy in it. It was a nice appearing tractor and ran well on the Iowa Tractor Pulling circut. I'm pretty sure it had a Turbo 400 behind it. Most "Hot Rods" in the 70's and early 80's had an automatic between the engine and rear end. I had an Oliver 88 witn a blown 482 Chevy and a turbo 400 connected to the rear end by a double roller chain coupler. Loads of fun!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
