Tractor Talk Discussion Board |
Re: Liquid Ballast vs. Iron Weights
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by buickanddeere on July 30, 2004 at 08:29:20 from (192.75.48.150):
In Reply to: Re: Liquid Ballast vs. Iron Weights posted by Ron on July 30, 2004 at 04:37:09:
Energy to accelerate the cast weights to speed is then converted to heat when stopped by the brakes or drag from the load. Any extra weight carried on the tractor does increase rolling friction in both the tire and the ground below it. Be it cast, fluid or equipment The fluid as well as using energy to climb the rising side of the tire and being dragged down the leading edge of the tire. Is subject to random sloshing. The slosh energy is always taken from either rotation or the linear travel in the direction of the tractor. However the sloshes rarely return energy in the direction that created them. The sloshes are dissipated against the sides of the tire (x axis), a vertical motion (Y axis) or in the (Z axis) in the opposite direction the tractor is traveling. Then there the pumping action just above the tread contact surface. The sidewall widens and then pushes fluid out of the way in order to narrow again. As for the slosh in the correct direction returning the energy that created it? Try dropping a rubber ball. It bounces back up but at a lower amplitude and lower with each bouce. The energy that initially raised that ball has been converted to heat by the ball and floor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|