|
Tractor Talk Discussion Board |
Giving Away Farmall H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matt Isserstedt on August 03, 2004 at 04:48:45 from (198.208.160.27):
Hi All, Ive moved around the country a few times and have been living in a subdivision for the last 5 years. I got into building a machine shop and the '49 H I was going to restore has been in storage the whole time with minimal progress. It's time to own up to the fact that I probably won't get to use this one and cut my storage expenses. The tractor is in a good state of disassembly, but I have bagged, tagged and labeled the parts. Starter motor has been rebuilt. Radiator has a hole in the bottom but I've built a new brass stud-socket for it...just need a shop to repair it. Front end has the usual dings but is not mangled. The tractor came from AZ and was setup originally for cotton. Single tire front, one axle shaft is the optional super extra long version. The other side has been torched off short (not by me). Tires are basically shot. I'd like it to go to a good home where someone can enjoy it and use it someday rather than someone looking to part it out for profit. Hopefully I have posted in the right place. I'm on the NW side of Atlanta, GA, you will have to pick it up with your trailer. I can assist with ramps, come-alongs, etc to get it loaded. Bring binders & chains or I won't let it go on your trailer...seen too many accidents with poor tie-down equipment. Please email me if interested rather than posting a reply. Thanks!
-Matt
matt dot isserstedt at gm dot com
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
