Tractor Talk Discussion Board |
Re: haywagon deck protection
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by UFO Man on August 15, 2004 at 11:21:00 from (66.243.138.44):
In Reply to: haywagon deck protection posted by Farmer in the Dells (WI) on August 15, 2004 at 08:25:26:
Bob, If it was me, I wouldn't put anything on it. Even if it is outdoors for a rain shower, the wood won't pick up enough moisture to hurt it if you allow it to dry. Keeping it under shelter will be all the protection it needs. If you have to do anything, paint it with exterior grade paint, priming correctly will keep it from flaking. Amimals can eat paint chips without harm since there isn't any lead in paint anymore. Latex is just an inert substance when it dries and passes through their gut. I prefer a rougher texture surface on hay wagons or hay hauling trucks. Hay particles are slick enough to keep your footing on without adding a slick surface underneath. A few years ago, I was helping a neighbor put up his hay. His son driving the pick up, he was on the ground throwing to me in the back of the truck. He had a full bed liner in the truck. The truck hits a bump, my feet go straight out in front of me, my butt hits the top of the bed and I flipped out onto the ground, landing on my head and shoulders. Luckily, I just kept rolling avoiding the trailer that we were pulling. But since I've gotten a bit older, I don't enjoy getting dumped like that anymore. Hope this helps. UFO Man
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|