Tractor Talk Discussion Board |
Re: Borrowing 28 GPM of hydraulic oil from 806
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by david val on August 19, 2004 at 01:41:07 from (80.230.188.76):
In Reply to: Borrowing 28 GPM of hydraulic oil from 806 posted by dfarmann on August 18, 2004 at 20:22:56:
the 3/4" opening may be sufficient if you don't narrow it with an adaptor. see if its practical to install a flange fitting. if the opening area is flat you need to work the casting into a smooth finish around the opening and drill and tap two holes for the flange bolts. if the bottom casting is thick enough.(you can see that in the plug opening), you can drill blind holes. this is a no pressure line and the flange bolts only hold the flange and its tubing so the flange bolt holes can be shallow. david
Follow Ups:
Home
| Forums
Today's Featured Article -
A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|