Tractor Talk Discussion Board |
Re: Newbie about to purchase first tractor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by txblu on September 02, 2004 at 05:57:00 from (199.46.199.231):
In Reply to: Re: Newbie about to purchase first tractor posted by Indydirtfarmer on September 02, 2004 at 04:03:36:
Not familiar with that tractor. Don't know if it's 30 or 300 hp which would surely make a difference. Agree with the handiness of the loader. Sometimes they get in the way, but once you have one you won't be without (been there done that). I think the $1000 is a little soft. New they are around $4k, again depending on size. A fresh overhaul on a diesel from a reputable shop is a super plus. The fact that you confirmed the work with the workers is excellent. I was worried about the ether comment but you covered that with your info about the starting aid not being operational. Don't know where you are located so ether might be a necessity. Since some Original Equipment Mfgrs. (OEM) put ether dispensers on their tractors, it can't be all bad if used according to directions....engine cranking and a little squirt or two. Seems that most all farm tires are weather cracked. I have some less than 2 yrs old that sit under a shed and are already starting to crack. If they are physically intact otherwise, that shouldn't be a problem. So take off the loader at $1500 and the overhaul for $2k (1k parts, 1k labor) and $1000 worth of tires you don't have to buy and the guy is giving you the tractor with a $500 bill wrapped around it to boot. Sounds like a heck of a deal to me. I usually have to pay $4k for the tractor (40 hp area), then overhaul it, then paint, fix little things broken, then new rubber, wind up out $6500 and no loader. Good luck on your decision. Mark
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|