Tractor Talk Discussion Board |
Re: Haying Question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JMS/MN on September 24, 2004 at 18:14:54 from (204.73.106.15):
In Reply to: Re: Haying Question posted by John S-B on September 24, 2004 at 18:03:38:
Try baling in 2nd or 3rd. 1st is too slow if the windrow is light. Pickup just bumps the hay around. It needs some flow to make it go through. Watch the speed of the pickup in relation to the ground speed. It should pretty much match. If you go to fast you'll see the windrow being broken up, left behind, rather than flowing in at a smooth rate. 1st gear is way to slow to bale an average windrow.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|