Tractor Talk Discussion Board |
Bush Hog Safety
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ichabod on September 26, 2004 at 09:07:01 from (67.50.82.13):
One day last week I was at the farm running the Bush Hog mowing some sweetgum saplings in thinned crp pines. Accidentally hit a pine stump and the Hog lost a blade. Made an awful noise, shook everything real bad. The blade came to rest about two feet in front of and about one foot outside the left rear wheel. I shut everything down and called it a day. Yesterday when I checked over the tractor I found a hole in the right rear fender about the same size and shape as the end of the mower blade. It was about chest high on me when I'm in the seat. When I saw that hole I know I got sick to my stomach. I'm quite sure I missed death by just a few inches that day. The bolt end of the blade broke off about half way the bolt hole. I plan to carefully check the ends of both blades from now on. That is if I can get the courage to use the mower again. Be careful out there. Ichabod
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|