Tractor Talk Discussion Board |
Re: OT/ hay baler conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Errin OH on October 11, 2004 at 07:04:22 from (168.73.245.53):
In Reply to: OT/ hay baler conversion posted by BSer on October 10, 2004 at 07:57:09:
I suspect it be a waste of time as well. Given one or two cans can support a 40lb concret block. The fact most balers are only designed to apply a few hundred pounds of pressure at the plunger. And the number of cans that it gonna take to fill the bale chamber, Just isn't gonna happen. I have, however, seen a home made can smasher. Fella had a pice of square tubing with a plunger powered with an electric motor. Mounted Horz, had 1" slot in the bottom the smashed can fell through into a box. It had a sleave that'd hold 6-8 cans. Even though it feed them in after each stroke, that sleave still had to fed by hand. Not real fast, still it smash up cans in a hurry. He'd take in $4-500 a month with it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil’s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|