Tractor Talk Discussion Board |
Re: JD water pump
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DLM on October 16, 2004 at 19:48:33 from (204.118.157.162):
In Reply to: JD water pump posted by JD Jim A. on October 16, 2004 at 19:10:00:
Does that pump have a cast pulley or a tin pulley if it is a tin pulley it is a good idea to replace the hub i have seen thoes hubs come off when used the second time but the cast pulleys can be used over. You should be able to pull that pulley off with a 5 or 10 ton puller attatch the puller legs to the bolt holes they are not on that hard. When you install the new bearing be sure to press on the outer race only if you don't the bearing will not last.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|